HP Array Controller HSG V8.7 Software - Manual (Page 56)

2–2 HSG80 User’s Guide
Introduction
Use the Getting Started Guide that came with your subsystem to
unpack and set up your subsystem prior to configuring your controller.
Unless you specifically requested a preconfigured subsystem, you will
have to configure your controller and its subsystem before you can use
them.
For the complete syntax and descriptions of the CLI commands used in
the configuration procedure, see Appendix B, “CLI Commands.”
Configuration Rules
Before you configure your controller, review these configuration rules
and ensure your planned configuration meets the requirements and
conditions.
n Maximum 128 visible LUNs/200 assignable unit numbers
n Maximum 512 GB LUN capacity
n Maximum 72 physical devices
n Maximum 20 RAID-5 storagesets
n Maximum 30 RAID-5 and RAID-1 storagesets
n Maximum 45 RAID-5, RAID-1, and RAID-0 storagesets
n Maximum 8 partitions of a storageset or individual disk
n Maximum 6 members per mirrorset
n Maximum 14 members per RAID-5 storageset
n Maximum 24 members per Stripeset
n Maximum 48 physical devices per striped mirrorset