HP Array Controller HSG V8.7 Software - Manual (Page 331)

CLI Commands B–59
DELETE FAILEDSET
Removes a disk drive from the failedset. The failedset contains disk
drives removed by the controller from RAIDsets and mirrorsets because
they failed or were manually removed using the SET command. Enter
the DELETE FAILEDSET command before physically removing failed
disks from the storage shelf for testing, repair, or replacement.
You should consider all disk drives in the failedset defective. Repair or
replace disks found in the failedset.
Syntax
DELETE FAILEDSET disk-name
Parameter
disk-name
Identifies the disk you want to delete from the failedset. Only one disk
at a time can be removed from a failedset.
Example
To delete DISK20200 from the failedset, use the following command:
DELETE FAILEDSET DISK20200
See also
DELETE container-name
DELETE SPARESET
SET FAILEDSET
SHOW FAILEDSET