HP Array Controller HSG V8.7 Software - Manual (Page 142)

3–64 HSG80 User’s Guide
Example
The following example shows the commands you would use to add
DISK60000 and DISK60100 to the spareset.
ADD SPARESET DISK60000
ADD SPARESET DISK60100
SHOW SPARESET
Removing a Disk Drive from the Spareset
You cannot delete the spareset—it always exists whether or not it
contains disk drives. However, you can delete disks in the spareset if
you need to use them elsewhere in your StorageWorks subsystem.
To remove a disk drive from the spareset:
1. Show the contents of the spareset using the following command:
SHOW SPARESET
2. Delete the desired disk drive using the following command:
DELETE SPARESET DISK nnnnn
Verify the contents of the spareset using the following command:
SHOW SPARESET
Example
The following example shows the commands you would use to remove
DISK60000 from the spareset.
SHOW SPARESET
DELETE SPARESET DISK60000
SHOW SPARESET
Name Storageset Uses Used by
SPARESET spareset disk60000
disk60100
Name Storageset Uses Used by
SPARESET spareset disk60100