HP Array Controller HSG V8.7 Software - Manual (Page 317)

CLI Commands B–45
CONFIGURATION RESET
Erases the entire configuration on “this controller,” restores the
controller’s default configuration, and shuts down the controller.
Note If you plan to use this feature, SAVE_CONFIGURATION must
be set when you initialize the container. See “INITIALIZE,” page
B–71.
Specify the CONFIGURATION RESET command on “this controller”
in nofailover mode only. Enter this command to ensure all of the old
configuration information is removed when a controller is moved from
one subsystem to another.
This command disables communication between host and controller.
Enter new configuration information through the SET
THIS_CONTROLLER command or the CONFIGURATION
RESTORE command to make the controller operational.
You can also initiate the CONFIGURATION RESET command from
the controller’s operator control panel (OCP) by holding in port button
5 and pressing the reset button.
Syntax
CONFIGURATION RESET
See also
CONFIGURATION RESTORE
CONFIGURATION SAVE
INITIALIZE