HP Array Controller HSG V8.7 Software User Manual
Page 556
I–8
HSG80 User’s Guide
mapping in subsystem, 4–25
maximum number in striped mirrorsets, 1–6,
maximum number supported, 1–5, 2–2
number per port, 1–5
renaming the volume serial number with the
CHVSN utility, 1–17
replacing, 5–47
setting data transfer rate, B–12, B–111
SHOW device-type, B–144
showing, B–143
testing read and write capability, 4–38
testing read capability, 4–37
transfer rate, 3–46
upgrading firmware, 6–11
Diagnostics
ECB charging, 1–29
listing of, B–67
running, B–95
DILX, 4–37
general description, 1–15
DILX, running, B–95
DIMMs
cache module memory configurations, 1–18
installing, 5–44
dual-redundant controller configuration,
single-configuration controller, 5–44
removing, 5–43
dual-redundant controller configuration,
single-configuration controller, 5–43
replacing, 5–42
replacing in a dual-redundant controller
configuration, 5–42
replacing in a single-configuration controller,
supported, 1–5
DIRECT, running, B–96
DIRECTORY, B–67
DISABLE_ACCESS
SET unit-number, B–138
DISABLE_ACCESS_PATH
ADD UNIT, B–28
Disabling
autospare, 3–65
Disabling the ECBs
shutting down the subsystem, 5–48
Disk drive. See devices
Disk drives
adding, 3–55
adding to configuration, B–11
adding to spareset using CLI, 3–63
adding with the CONFIG utility, 1–15
array, 3–8
corresponding storagesets, 3–32
deleting, B–57
displaying information, B–143
dividing, 3–37
formatting with HSUTIL, 1–16
generating a new volume serial number with the
CHVSN utility, 1–17
generating read and write loads with DILX,
initializing, B–71
investigating data transfer with DILX, 1–15
largest device supported, 1–6, 2–2
making transportable, B–111
mirroring, B–79
monitoring performance with DILX, 1–15
partitioning, 3–61
partitions supported, 2–2
removing from a mirrorset, B–85
removing from sparesets using CLI, 3–64
removing from the failedset, B–59
removing from the spareset, B–61
renaming, B–89
renaming the volume serial number with the
CHVSN utility, 1–17
setting device data transfer rate, B–12
showing, B–143 to B–144
transfer rate, B–12
upgrading the firmware with HSUTIL, 1–16