HP Array Controller HSG V8.7 Software - Manual (Page 287)

CLI Commands B–15
ADD MIRRORSET
Names a mirrorset and adds it to the controller configuration.
Syntax
ADD MIRRORSET mirrorset-name disk-name1 [disk-nameN]
Parameters
mirrorset-name
Assigns a name to the mirrorset. This is the name used with the ADD
UNIT command to identify the mirrorset as a host-addressable unit.
The mirrorset name must start with a letter (A through Z) and may
consist of a maximum of nine characters including letters A through Z,
numbers 0 through 9, periods (.), dashes (-), or underscores (_).
Tip It is common to name a mirrorset MIRRn, where n is a
sequentially-assigned, unique identifier. Other naming conventions are
acceptable, but this naming convention presents both the type of
container and its unique identifier.
disk-name1 [disk-nameN]
Identifies the disk drives making up the mirrorset. A mirrorset may
contain one to six disk drives.
Switches
COPY=FAST
COPY=NORMAL (Default)
Sets the speed at which the controller copies data to a new member
from normal mirrorset members when data is being mirrored to the
storageset’s disk drives.
Specify COPY=FAST to allow the creation of mirrored data to take
precedence over other controller operations. When you specify
COPY=FAST, the controller uses more resources to create the mirrored
data, and copying takes less time. However, overall controller
performance is reduced during copying.