HP Array Controller HSG V8.7 Software - Manual (Page 509)

Event Reporting: Templates and Codes D–75
80050100 DILX tried to change the usb unit state from MAINTENANCE_MODE to NORMAL
but DILX never received notification of a successful state change.
80060100 DILX tried to switch the unit state from MAINTENANCE_MODE to NORMAL but
was not successful.
80070100 DILX aborted all cmds via va$d_abort() but the HTBS haven’t been returned.
80090100 DILX received an end msg which corresponds to an op code not supported by DILX.
800A0100 DILX was not able to restart his timer.
800B0100 DILX tried to issue an I/O for an opcode not supported.
800C0100 DILX tried to issue a oneshot I/O for an opcode not supported.
800D0100 A DILX device control block contains an unsupported unit_state.
800F0100 A DILX cmd completed with a sense key that DILX does not support.
80100100 DILX could not compare buffers because no memory was available from
EXEC$ALLOCATE_MEM_ZEROED.
80110100 While DILX was deallocating his deferred error buffers, at least one could not be
found.
80120100 DILX expected an Event Information Packet (EIP) to be on the receive EIP queue but
no EIPs were there.
80130100 DILX was asked to fill a data buffer with an unsupported data pattern.
80140100 DILX could not process an unsupported answer in dx$reuse_params().
80150100 A deferred error was received with an unsupported template.
83020100 An unsupported message type or terminal request was received by the CONFIG virtual
terminal code from the CLI.
83030100 Not all alter_device requests from the CONFIG utility completed within the timeout
interval.
83050100 An unsupported message type or terminal request was received by the CFMENU
utility code from the CLI.
83060100 Not all alter_device requests from the CFMENU utility completed within the timeout
interval.
Table D–3 Last Failure Codes (Continued)
Code Description