HP Array Controller HSG V8.7 Software - Manual (Page 151)

Creating Storagesets 3–73
1. Show the details for the storageset you want to move. Use the following
command:
SHOW storageset-name
2. Label each member with its name and PTL location.
If you do not have a storageset map for your subsystem, you can enter
the LOCATE command for each member to find its PTL location. Use
the following command:
LOCATE disk-name
To cancel the locate command, enter the following:
LOCATE CANCEL
3. Delete the unit-number shown in the “Used by” column of the SHOW
storageset-name command. Use the following command:
DELETE unit-number
4. Delete the storageset shown in the “Name” column of the SHOW
storageset-name command. Use the following command:
DELETE storageset-name
5. Delete each disk drive—one at a time—that the storageset contained.
Use the following command:
DELETE disk-name
DELETE disk-name
DELETE disk-name
6. Remove the disk drives and move them to their new PTL locations.
7. Add again each disk drive to the controller’s list of valid devices. Use
the following command:
ADD DISK disk-name PTL-location
ADD DISK disk-name PTL-location
ADD DISK disk-name PTL-location
8. Recreate the storageset by adding its name to the controller’s list of
valid storagesets and specifying the disk drives it contains. (Although
you have to recreate the storageset from its original disks, you do not
have to add them in their original order.) Use the following command:
ADD storageset-name disk-name disk-name