HP Array Controller HSG V8.7 Software User Manual
Page 510
D–76
HSG80 User’s Guide
84010100
An unsupported message type or terminal request was received by the CLONE virtual
terminal code from the CLI.
85010100
HSUTIL tried to release a facility that wasn’t reserved by HSUTIL.
85020100
HSUTIL tried to change the unit state from MAINTENANCE_MODE to NORMAL
but was rejected because of insufficient resources.
85030100
HSUTIL tried to change the usb unit state from MAINTENANCE_MODE to
NORMAL but HSUTIL never received notification of a successful state change.
85040100
HSUTIL tried to switch the unit state from MAINTENANCE_MODE to NORMAL
but was not successful.
86000020
Controller was forced to restart in order for new code load or patch to take effect.
86010010
The controller code load function is about to update the program card. This requires
controller activity to cease. This code is used to inform the other controller this
controller will stop responding to inter-controller communications during card update.
An automatic restart of the controller at the end of the program card update will cause
normal controller activity to resume.
86020011
The EMU firmware returned a bad status when told to prepare for a code load. Last
Failure Parameter [0] contains the value of the bad status.
8A040080
New cache module failed diagnostics. The controller has been reset to clear the error.
8A050080
Could not initialize new cache module. The controller has been reset to clear the error.
8B000186
An single bit error was found by software scrubbing.
n
Last Failure Parameter [0] contains the address of the first single bit ecc error
found.
n
Last Failure Parameter [1] contains the count of single bit ecc errors found in the
same region below this address.
n
Last Failure Parameter [2] contains the lower 32-bits of the actual data read at the
Parameter [0] address.
n
Last Failure Parameter [3] contains the higher 32-bits of the actual data read at the
Parameter [0] address.
n
Last Failure Parameter [4] contains the lower 32-bits of the expected data at the
Parameter [0] address.
n
Last Failure Parameter [5] contains the higher 32-bits of the expected data at the
Parameter [0] address.
Table D–3
Last Failure Codes (Continued)
Code
Description