HP Array Controller HSG V8.7 Software - Manual (Page 380)

B–108 HSG80 User’s Guide
PORT_1_TOPOLOGY=LOOP_HARD
PORT_1_TOPOLOGY=LOOP_SOFT
PORT_1_TOPOLOGY=OFFLINE
PORT_2_TOPOLOGY=LOOP_HARD
PORT_2_TOPOLOGY=LOOP_SOFT
PORT_2_TOPOLOGY=OFFLINE
Indicates whether the user or controller selects the ALPA for a host
port, or whether the port is to be set offline. LOOP_HARD allows you
to pick the ALPA. LOOP_SOFT requests the controller to pick the
ALPA. OFFLINE sets the host port offline. Specify OFFLINE for a
port when it will not be used.
PROMPT=“new prompt”
Specifies a 1- to 16-character prompt displayed when the controller’s
CLI prompts for input. Only printable ASCII characters and spaces are
valid. The new prompt name must be enclosed within quotes. When
changed, the new text entered for this switch takes effect immediately.
SCSI_VERSION=SCSI-2 (Default)
SCSI_VERSION=SCSI-3
Specifies the host protocol to use; requires operating system support.
SCSI-3 is limited SCSI-3. It also specifies how the command console
LUN is handled. The command console LUN (CCL) presents to the
GUI a virtual LUN through which it communicates with the controller.
SCSI-2 specifies that the CCL is not fixed at a particular location, but
floats depending on the configuration.
SCSI-3 specifies that the LLC is fixed at LUN 0. The SCSI device-type
returned to the host is array controller.
Changes to this switch take place at the next controller restart.
TERMINAL_PARITY=ODD
TERMINAL_PARITY=EVEN
NOTERMINAL_PARITY (Default)
Specifies the parity with which data is transmitted and received. When
changed, the new setting for this switch takes effect immediately.