HP Array Controller HSG V8.7 Software - Manual (Page 276)

B–4 HSG80 User’s Guide
Specific keys or a combination of keys allow you to recall and edit the
last four commands. This feature can save time and help prevent
mistakes when you need to enter similar commands during the
configuration process. Table B–1 lists the keys used to recall and edit
commands.
Changing the CLI Prompt
You can change the CLI prompt that displays. Use the SET
THIS_CONTROLLER PROMPT= command. Enter a 1- to 16-
character string as the new prompt. For example, you could use the
prompt to indicate the array controller’s name, such as “HSG>.”
Table B–1 Recall and Edit Command Keys
Key Function
Up Arrow or Ctrl/B,
Down Arrow or Ctrl/N Steps backward and forward through the
four most recent CLI commands.
Left arrow or Ctrl/D,
Right arrow or Ctrl/F Moves the cursor left or right in a command
line.
Ctrl/E Moves the cursor to the end of the line.
Ctrl/H or Backspace or
F12 Moves the cursor to the beginning of the
line.
Ctrl/J or Linefeed or
F13
Deletes the word to the left of the cursor.
Ctrl/U
Deletes all characters on the same line as the
cursor.
Ctrl/A or F14
Toggles between insert mode and overstrike
mode. The default setting is insert mode,
which allows you to insert characters at the
cursor location, moving the existing
characters to the right. Overstrike mode
replaces existing characters. The CLI returns
to insert mode at the beginning of each line.
Ctrl/R
Recalls the contents of the command line.
This is especially helpful if the system
issues a message that interrupts your typing.