HP Array Controller HSG V8.7 Software - Manual (Page 201)

Replacement Procedures 5–5
6. See “Configuring an HSG80 Array Controller,” page 2–3, to configure
the controller.
Note If the controller you’re installing was previously used in another
subsystem, it will need to be purged of the controller’s old
configuration (see “CONFIGURATION RESET,” page B–45).
7. To restore a configuration saved with the SAVE_CONFIGURATION
switch, hold button 6 while releasing the reset button.
8. Using CLCP, install any patches that you had installed on the previous
controller (see “Installing a Software Patch,” page 6–6).
9. Mount the logical units on the host. If you are using a Windows NT
platform, restart the server.
10. Set the subsystem date and time with the following command:
SET THIS_CONTROLLER TIME= dd-mmm-yyyy:hh:mm:ss
11. Disconnect the PC or terminal from the controller’s maintenance port.