HP Array Controller HSG V8.7 Software - Manual (Page 297)

CLI Commands B–25
ADD STRIPESET
Names a stripeset and adds it to the controller configuration. Stripesets
are sometimes referred to as RAID level 0 storagesets. The number of
members in the stripeset is determined by the number of container-
name parameters specified.
Syntax
ADD STRIPESET stripeset-name container-name1 container-name2
[container-nameN]
Parameters
stripeset-name
Assigns a name to the stripeset. This is the name used with the ADD
UNIT command to identify the stripeset as a host-addressable unit.
container-name1 container-name2 [container-nameN]
Identifies the members (disk drives or mirrorsets) making up the
stripeset. Stripeset can contain between 2 and 14 members.
The container name must start with a letter (A through Z) and may
consist of a maximum of nine characters including letters A through Z,
numbers 0 through 9, periods (.), dashes (-), or underscores (_).
Tip It’s common to name a stripeset STRIPEn, where n is a
sequentially-assigned, unique identifier. This naming convention
presents both the type of container and its unique identifier.
Note There is a 240 character limit for the command line. If you are
configuring a stripeset with multiple members (for example, more than
20) you will have to rename the members in order to execute the
command.