HP Array Controller HSG V8.7 Software - Manual (Page 147)

Creating Storagesets 3–69
To turn it off, use the following command:
SET THIS_CONTROLLER NOCOMMAND_CONSOLE_LUN
Caution Disabling the CCL while SWCC is running may result in loss
of connection for the StorageWorks Command Console. Turn off
SWCC before issuing the command.
Finding the CCL Location
To see where each CCL is located, use the following commands:
SHOW THIS_CONTROLLER
or
SHOW OTHER_CONTROLLER
Look under host port to find the Command Console LUN location.
Because the CCL is not an actual device or unit, the SHOW UNITS
command will display only unit information and no CCL locations.
Multiple-Bus and Transparent Failover in SCSI-2 and SCSI-3 Modes
The way the host sees the CCL varies, depending on whether you’ve
enabled transparent or multiple-bus failover modes and whether you are
in SCSI-2 or SCSI-3 mode.
SCSI-2 Mode
Multiple-Bus Failover
If SET MULTIBUS_FAILOVER is enabled, all ports will be able to see
and access the CCL. In addition, the CCL appears to the host as a direct
access device.
Transparent Failover
If you are in SCSI-2 mode and have enabled the SET FAILOVER
command, only one CCL will be enabled.