Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) User Manual

Page 90

Brocade Mobility 7131 Access Point Product Reference Guide

53-1002517-01

2. Use the AP-71xx Access field checkboxes to enable/disable the following on the access point’s

LAN1, LAN2 or WAN interfaces:

3. Refer to the Applet Timeout field to set an HTTPS timeout interval.

4. Configure the Secure Shell field to set timeout values to reduce network inactivity.

Applet HTTP (port 80) Select the LAN1, LAN2 and/or WAN checkboxes to enable access to the Mobility 7131

Access Point configuration applet using a Web browser.

Applet HTTPS (port
443)

Select the LAN1, LAN2 and/or WAN checkboxes to enable access to the Mobility 7131
Access Point configuration applet using a Secure Sockets Layer (SSL) for encrypted HTTP
sessions.

CLI TELNET (port 23)

Select the LAN1, LAN2 and/or WAN checkboxes to enable access to the Mobility 7131
Access Point CLI via the TELNET terminal emulation TCP/IP protocol.

CLI SSH (port 22)

Select the LAN1, LAN2 and/or WAN checkboxes to enable access to the Mobility 7131
Access Point CLI using the SSH (Secure Shell) protocol.

SNMP (port 161)

Select the LAN1, LAN2 and/or WAN checkboxes to enable access to the Mobility 7131
Access Point configuration settings from an SNMP-capable client.

HTTP/S Timeout

Disables access to the access point if no data activity is detected over Applet HTTPS
(port 443) after the user defined interval. Default is 0 Mins.