Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 315)

Brocade Mobility 7131 Access Point Product Reference Guide 303
53-1002517-01
8
Example:
admin(network.wan)>
admin(network.wan)>
set dhcp disable
admin(network.wan)>
set ipadr 157.169.22.5
admin(network.wan)>
set dgw 157.169.22.1
admin(network.wan)>
set dns 1 157.169.22.2
admin(network.wan)>
set auto-negotiation disable
admin(network.wan)>
set speed 10M
admin(network.wan)>
set duplex half
admin(network.wan)>
set mask 255.255.255.000
admin(network.wan)>
set pppoe mode enable
admin(network.wan)>
set pppoe type chap
admin(network.wan)>
set pppoe user jk
admin(network.wan)>
set pppoe passwd @#$goodpassword%$#
admin(network.wan)>
set pppoe ka enable
admin(network.wan)>
set pppoe idle 600
admin(network.wan)>
set wwan mode disable
For an overview of the WAN configuration options available using the applet (GUI), see Configuring
WAN Settings on page 5-127.
Network WAN NAT Commands
br7131>admin(network.wan.nat)>
Description:
Displays the NAT submenu. The items available under this command are shown below.
dns Sets the IP address of one or two DNS servers, where
indicates either the primary (
1 ) or secondary ( 2 ) server, and
is the IP address of the server.
auto-negotiatio
n enable / disable Enables or disables auto-negotiation for the access point WAN port.
speed Defines the WAN port speed as either 10 Mbps or 100 Mbps.
duplex Defines the access port WAN port duplex as either half or full.
pppoe enable / disable Enables or disables PPPoE.
user Sets PPPoE user name.
passwd Defines the PPPoE password.
ka enable / disable Enables or disables PPPoE keepalive.
idle Sets PPPoE idle time.
type Sets PPPoE authentication type.
wwan enable / fail-over Sets the 3G wireless WAN operations mode (disable/fail-over) for a
defined user name, password and remote gateway.
show Displays the Mobility 7131 Access Point’s current NAT parameters for the specified
index.
set Defines the Mobility 7131 Access Point NAT settings.
add Adds NAT entries.
delete Deletes NAT entries.