Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 291)

Brocade Mobility 7131 Access Point Product Reference Guide 279
53-1002517-01
7
5. Click the Send Cfg to APs button to send the your access point’s configuration to other access
point’s. The recipient access point must be the same single or dual-radio model as the access
point sending the configuration. The sending and recipient access point’s must also be
running the same major firmware version.
CAUTION
When using the Send Cfg to APs function to migrate an access point’s configuration to other
access points, it is important to keep in mind mesh network configuration parameters do not get
completely sent to other access points. The Send Cfg to APs function will not send the
“auto-select” and “preferred list” settings. Additionally, LAN1 and LAN2 IP mode settings will only
be sent if the sender’s AP mode is DHCP or BOOTP. The WAN’s IP mode will only be sent if the
sender’s IP mode is DHCP.
6. Click the Start Flash button to flash the LEDs of other Mobility 7131 Access Points detected
and displayed within the Known AP Statistics screen.
Use the Start Flash button to determine the location of the devices displayed within the
Known AP Statistics screen. When an Mobility 7131 Access Point is highlighted and the
Start Flash button is selected, the LEDs on the selected Mobility 7131 Access Point flash.
When the Stop Flash button is selected, the LEDs on the selected Mobility 7131 Access
Point go back to normal operation.
7. Click the Logout button to securely exit the Access Point applet. A prompt displays confirming
the logout before the applet is closed.