Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 353)

Brocade Mobility 7131 Access Point Product Reference Guide 341
53-1002517-01
8
Example:
admin(network.wireless.radio)>
set max-mus 127
admin(network.wireless.radio)>
set mesh-base 1 enable
admin(network.wireless.radio)>
set mesh-max 1 11
admin(network.wireless.radio)>
set mesh-client 1 disable
admin(network.wireless.radio)>
set mesh-roaming-client 1 enable
admin(network.wireless.radio)>
set mesh-wlan wlan1
admin(network.wireless.radio)>
set dot11-auth shared-key-allowed
CAUTION
A 40 MHz channel is composed of two 20 MHz subchannels. If the firmware detects radar within
the FCC 80 % detection band of the 40 MHz channel; the device must vacate the channel. If the
detected signal falls outside the FCC 80 % detection band of one of the 20 MHz subchannels; the
Master Device can legally move to that 20 MHz channel.
Three Radio SKU
mesh-signal-threshold
> Sets the threshold value in dbm in the range 30-100. Base bridge signal below
this threshold value is considered weak. This value is set on a per radio basis.
mesh-signal-delta Sets a value in dbm. This is the difference in base bridge signal strength before a
mesh link switch is attempted. This value is in the range 0-100 and is set per
radio.
mesh-wired-peer-detectio
n Enables or disables check for a peer AP connecte by wire. When enabled, this
configuration prevents the AP from creating a mesh connection with a peer AP
that is connected to it through wire. The AP continuously monitors its wired ports
for the presence of a peer AP. If a peer AP is detected on the wired side, the AP
makes a note of the peer APs MAC address. It then checks if a wireless mesh
connection to the peer AP is already present, and if found, drops the wireless
connection. The feature prevents an AP from forming a mesh connection with a
wired peer. This feature is set on a per radio basis.
mesh-auto-single-conn Enables or disables the restriction on the AP to form a mesh connection with
exactly one peer AP. either as a base bridge or as a client bridge. The AP creates a
mesh connection with an AP with the highest RSSI value seen while scanning.
Dependig on the radio’s MAC address, the AP either becomes a Client Bridge or a
Base Bridge. This feature is set on a per radio basis.
dot11-auth > Defines dot11 level authentication algorithm to either open-system-only or
shared-key-allowed .
qos-mapping
(wired-to-wireless) Sets the QoS mapping from wired to wireless.
set radio-config
1 Radio 1 WLAN, Radio 2 WLAN, Radio 3 WIPS
2 Radio 1 WLAN, Radio 2 WIPS, Radio 3 WIPS
3 Radio 1 WIPS, Radio 2 WLAN, Radio 3 WIPS
4 Radio 1 WLAN, Radio 2 WLAN, Radio 3 Disabled
5 Radio 1 WIPS, Radio 2 WIPS, Radio 3 Disabled
6 Radio 1 WLAN, Radio 2 Disabled, Radio 3 Disabled
7 Radio 1 Disabled, Radio 2 WLAN, Radio 3 Disabled
8 Radio 1 Disabled, Radio 2 Disabled, Radio 3 Disabled