Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 411)

Brocade Mobility 7131 Access Point Product Reference Guide 399
53-1002517-01
8
br7131>admin(system.snmp.traps)>show
Description:
Shows SNMP trap parameters.
Syntax:
Example:
admin(system.snmp.traps)>
show trap
SNMP MU Traps
mu associated : enable
mu unassociated : disable
mu denied association : disable
mu denied authentication : disable
SNMP Traps
snmp authentication failure : disable
snmp acl violation : disable
SNMP Network Traps
physical port status change : enable
denial of service : enable
denial of service trap rate limit : 10 seconds
SNMP System Traps
system cold start : disable
system config changed : disable
rogue ap detection : disable
ap radar detection : disable
wpa counter measure : disable
mu hotspot status : disable
vlan : disable
lan monitor : disable
DynDNS Update : enable
show Shows SNMP trap parameters.
set Sets SNMP trap parameters.
add Adds SNMP trap entries.
delete Deletes SNMP trap entries.
list Lists SNMP trap entries.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the configuration to system flash.
quit Quits the CLI.
show trap Shows SNMP trap parameter settings.
rate-trap Shows SNMP rate-trap parameter settings.