Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 242)

230 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
6
1. Configure the LAN1 interface by statically assigning an IP address of 10.1.1.1.
Viewing VPN Status
Use the VPN Status screen to display the status of the tunnels configured on the Mobility 7131
Access Point as well as their lifetime, transmit and receive statistics. The VPN Status screen is
read-only with no configurable parameters. To configure a VPN tunnel, use the VPN configuration
screen in the WAN section of the Mobility 7131 Access Point menu tree.
To view VPN status:
1. Select Network Configuration -> WAN -> VPN -> VPN Status from the Mobility 7131 Access
Point menu tree.
2. Reference the Security Associations field to view the following:
Tunnel Name The Tunnel Name column lists the names of all the tunnels configured on the Mobility
7131 Access Point. For information on configuring a tunnel, see Configuring VPN Tunnels
on page 6-216.
Status The Status column lists the status of each configured tunnel. When the tunnel is not in
use, the status reads NOT_ACTIVE . When the tunnel is connected, the status reads
ACTIVE .
Outb SPI The Outb SPI column displays the outbound Security Parameter Index (SPI) for each
tunnel. The SPI is used locally by the Mobility 7131 Access Point to identify a security
association. There are unique outbound and inbound SPIs.