Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 365)

Brocade Mobility 7131 Access Point Product Reference Guide 353
53-1002517-01
8
admin(network.wireless.radio.802-11n[5.0 GHz])>
set range 40
admin(network.wireless.radio.802-11n[5.0 GHz])>
set qbss-beacon 110
admin(network.wireless.radio.802-11n[5.0 GHz])>
set qbss-mode enable
admin(network.wireless.radio.802-11n[5.0 GHz])>
set single-antenna disable
admin(network.wireless.radio.802-11n[5.0 GHz])>
set dynamic-chain-selection enable
admin(network.wireless.radio.802-11n[5.0 GHz])>
set tkip-ht-compatibility disable
admin(network.wireless.radio.802-11n[5.0 GHz])>
set bcmc-tx-speed range
CAUTION
A 40 MHz channel is composed of two 20 MHz subchannels. If the firmware detects radar within
the FCC 80 % detection band of the 40 MHz channel; the device must vacate the channel. If the
detected signal falls outside the FCC 80 % detection band of one of the 20 MHz subchannels; the
Master Device can legally move to that 20 MHz channel.
For information on configuring the Radio 2 Configuration options available to the access point
using the applet (GUI), see
Configuring the 802.11a/n or 802.11b/g/n Radio on page 5-167.
br7131>admin(network.wireless.radio.802-11n[5.0 GHz].advanced)>
Description:
Displays the advanced submenu for the 802.11n (5.0 GHz) radio. The items available under this
command include:
Syntax:
br7131>admin(network.wireless.radio.802-11n[5.0
GHz].advanced)>show
Description:
Displays the BSSID to WLAN mapping for the 802.11n (5.0 GHz) radio.
Syntax:
show Displays advanced radio settings for the 802.11n (5.0 GHz) radio.
set Defines advanced parameters for the 802.11n (5.0 GHz) radio.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the configuration to system flash.
quit Quits the CLI.
show advanced Displays advanced settings for the 802.11n (5.0 GHz) radio.
wlan Displays WLAN summary list for 802.11n (5.0 GHz) radio.