Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 106)

94 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
4
2. Configure the SNMP v1/v2c Trap Configuration field (if SNMP v1/v2c Traps are used) to modify
the following:
3. Configure the SNMP v3 Trap Configuration field (if SNMP v3 Traps are used) to modify the
following:
Add Click Add to create a new SNMP v1/v2c Trap Configuration entry.
Delete Click Delete to remove a selected SNMP v1/v2c Trap Configuration entry.
Destination IP Specify a numerical (non DNS name) destination IP address for receiving the traps sent by
the Mobility 7131 Access Point SNMP agent.
Port Specify a destination User Datagram Protocol (UDP) port for receiving traps. The default is
162.
Community Enter a community name specific to the SNMP-capable client that receives the traps.
SNMP Version Use the SNMP Version drop-down menu to specify v1 or v2.
Some SNMP clients support only SNMP v1 traps, while others support SNMP v2 traps and
possibly both, verify the correct traps are in use with clients that support them.
Add Click Add to create a new SNMP v3 Trap Configuration entry.
Delete Select Delete to remove an entry for an SNMP v3 user.
Destination IP Specify a numerical (non DNS name) destination IP address for receiving the traps sent by
the Mobility 7131 Access Point SNMP agent.