Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 443)

Brocade Mobility 7131 Access Point Product Reference Guide 431
53-1002517-01
8
CAUTION
Brocade Mobility discourages importing a 1.0 baseline configuration file to a 1.1 (or later) version
access point. Similarly, a 2.0 baseline configuration file should not be imported to a 1.0 version
access point. Importing configurations between different version access point’s results in broken
configurations, since new features added to the 2.0 version access point cannot be supported in
a leagcy version access point.
For information on importing/exporting access point configurations using the applet (GUI), see
Importing/Exporting Configurations on page 4-104.
Firmware Update Commands
br7131>admin(system)>fw-update
Description:
Displays the firmware update submenu. The items available under this command are shown below.
NOTE
The access point must complete the reboot process to successfully update the device firmware,
regardless of whether the reboot is conducted uing the GUI or CLI interfaces.
br7131>admin(system.fw-update)>show
Description:
Displays the current Mobility 7131 Access Point firmware update settings.
Syntax:
Example:
admin(system.fw-update)>
show
show Displays the current Mobility 7131 Access Point firmware update settings.
set Defines the Mobility 7131 Access Point firmware update parameters.
update Executes the firmware update.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the current configuration to the Mobility 7131 Access Point system flash.
quit Quits the CLI and exits the current session.
show Shows the current system firmware update settings for the Mobility 7131 Access Point.