Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 313)

Brocade Mobility 7131 Access Point Product Reference Guide 301
53-1002517-01
8
-----------------------------------------------------------------------------
1 0806
2 0800
3 8782
admin(network.lan.type-filter)>
delete 2 all
admin(network.lan.type-filter)>
show 2
Ethernet Type Filter mode : allow
-----------------------------------------------------------------------------
index ethernet type
-----------------------------------------------------------------------------
For information on configuring the type filter settings using the applet (GUI), see Setting the Type
Filter Configuration on page 5-125.
Network WAN Commands
br7131>admin(network.wan)>
Description:
Displays the WAN submenu. The items available under this command are shown below.
For an overview of the WAN configuration options using the applet (GUI), see Configuring WAN
Settings on page 5-127.
br7131>admin(network.wan)>show
Description:
Displays the Mobility 7131 Access Point WAN port parameters.
Syntax:
show Displays the Mobility 7131 Access Point WAN configuration and the Mobility 7131 Access Point’s current PPPoE
configuration.
set Defines the Mobility 7131 Access Point’s WAN and PPPoE configuration.
delete Deletes WWAN CRM remote gateways.
nat Displays the NAT submenu, wherein Network Address Translations (NAT) can be defined.
vpn Goes to the VPN submenu, where the Mobility 7131 Access Point VPN tunnel configuration can be set.
content Goes to the outbound content filtering menu.
dyndns Displays the Dynamic DNS submenu, wherein dyndns settings can be defined.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the current configuration to the Mobility 7131 Access Point system flash.
quit Quits the CLI and exits the current session.
show Shows the general IP parameters for the WAN port along with settings for the WAN interface.