Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 491)

Brocade Mobility 7131 Access Point Product Reference Guide 479
53-1002517-01
10
• Adaptive AP Configuration
• Switch Configuration
NOTE
Refer to Adaptive AP Deployment Considerations on page 10-483 for usage and deployment caveats
that should be considered before defining the AAP configuration. Refer to Sample Switch
Configuration File for IPSec and Independent WLAN on page 10-484 if planning to deploy an AAP
configuration using IPSec VPN and an extended WLAN.
Adaptive AP Configuration
An AAP can be manually adopted by the switch, adopted using a configuration file (consisting of the
adaptive parameters) pushed to the access point or adopted using DHCP options. Each of these
adoption techniques is described in the sections that follow.
Adopting an Adaptive AP Manually
To manually enable the access point’s switch discovery method and connection medium required
for adoption:
1. Select System Configuration -> Adaptive AP Setup from the access point’s menu tree.
2. Select the Auto Discovery Enable checkbox.
Enabling auto discovery will allow the AAP to be detected by a switch once its connectivity
medium has been configured (by completing steps 3-6)