Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 321)

Brocade Mobility 7131 Access Point Product Reference Guide 309
53-1002517-01
8
Syntax:
set type Sets the tunnel type to Auto or Manual for
the specified tunnel name.
authalgo Sets the authentication algorithm for to ( None ,
MD5 , or SHA1 ).
authkey Sets the AH authentication key (if type is Manual) for
tunnel with the direction set to
IN or OUT, and
the manual authentication key set to . (The
key size is
32 hex characters for MD5, and 40 hex
characters for SHA1).
esp-type Sets the Encapsulating Security Payload (ESP) type.
Options include
None , ESP , or ESP-AUTH .
esp-encalgo Sets the ESP encryption algorithm. Options include
DES , 3DES , AES128 , AES192 , or AES256 ).
esp-enckey Sets the Manual Encryption Key in ASCII for tunnel
and direction
IN or OUT to the key .
The size of the key depends on the encryption algorithm.
- 16 hex characters for DES
- 48 hex characters for 3DES
- 32 hex characters for AES128
- 48 hex characters for AES192
- 64 hex characters for AES256
esp-authalgo Sets the ESP authentication algorithm. Options include
MD5 or SHA1 .
esp-authkey Sets ESP Authentication key either for IN or
OUT direction to , an ASCII string of hex
characters. If authalgo is set to MD5 , then provide 32
hex characters. If authalgo is set to SHA1 , provide 40
hex characters.
spi Sets 6 character IN (bound) or OUT (bound) for AUTH
(Manual Authentication) or ESP for to (a
hex value more than 0xFF) .
usepfs Enables or disables Perfect Forward Secrecy for
.
salife Defines the name of the tunnnel the Security
Association Life Time <300-65535> applies to in
seconds.
ike opmode Sets the Operation Mode of IKE for to Main or
Aggr (essive).
myidtype Sets the Local ID type for IKE authentication for
(1 to 13 characters) to (
IP , FQDN , or
UFQDN ).