Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 352)

340 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
8
Client Bridge Signal Monitor : enable
Client Bridge Signal Threshold : 65
Client Bridge Signal Delta : 10
Mesh Wired Peer Detection Mode : disable
Mesh Auto Single Connection Mode : disable
Dot11 Auth Algorithm : open-system-only
DSCP QOS Mappings:
DSCP value : Wireless Traffic ID (WMM
AC)
0 1 2 3 4 5 6 7 : 0 (best-effort)
8 9 10 11 12 13 14 15 : 1 (background)
16 17 18 19 20 21 22 23 : 2 (background)
24 25 26 27 28 29 30 31 : 3 (best-effort)
32 33 34 35 36 37 38 39 : 4 (video)
40 41 42 43 44 45 47 : 5 (video)
46 48 49 50 51 52 53 54 55 : 6 (voice)
56 57 58 59 60 61 62 63 : 7 (voice)
For information on configuring the Radio Configuration options available to the access point using
the applet (GUI), see Setting the Radio Configuration for a WLAN on page 5-161.
br7131>admin(network.wireless.radio)>set
Description:
Sets the Mobility 7131 Access Point’s radio configuration and defines the RF band of operation.
Syntax:
set radio-config Sets the radio configuration. The options available differ depending on the single,
dual or three radio configuration deployed (see examples below).
max-mus Defines the maximum number of MUs assigned to the specified radio (idx 1 or 2).
The range can be defined between 0 and 127. This command does not apply to
single radio access points.
mesh-auto-mode Enables or disables the Auto-Mesh Mode feature. When enabled, the Auto-Mesh
Mode feature enables an AP to become a Base Bridge and a Client Bridge
simultaneously. This feature enables the AP to be a Client Bridge and connect to a
Base Bridge while serving as a Base Bridge for other Client Bridge APs.
mesh-base Enables or disables base bridge mode.
mesh-max Sets the maximum number of wireless bridge clients.
mesh-client Enables or disables client bridge mode.
mesh-roaming-client Enables or disables the mesh roaming client mode. For information on the Mesh
Roaming Client feature, see Mesh Roaming Client on page 1-9.
mesh-timeout Sets the client bridge link timeout.
mesh-wlan Defines the client bridge WLAN name.
mesh-associations Sets the maximum client bridge associations per radio. Sets a value in the range
1-3 per radio.
mesh-monitor Enables or diables mesh link monitoring on client bridge per radio.