Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 166)

154 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
5
5. Select the Enable Hotspot User Timeout checkbox to define a timeout interval forcing users
(when exceeded) to re-establish their login credentials to continue using the access point
supported hotspot.
Leaving the checkbox unselected is not recommended unless you plan to provide
unlimited hotspot support to users.
If this option is selected, enter an interval (between 15 and 180 minutes). When the
provided interval is exceeded, the user is logged out of their hotspot session and forced to
login to the hotspot again to access to the hotspot supported WLAN. The default timeout
interval is 15 minutes.
NOTE
The Enable Hotspot User Timeout option is only available if using the access point’s internal Radius
Server for user authentication.
6. Click the White List Entries button (within the WhiteList Configuration field) to create a set of
allowed destination IP addresses. These allowed destination IP addresses are called a White
List. Ten configurable IP addresses are allowed for each WLAN. For more information, see
Defining the Hotspot White List on page 5-155.
NOTE
If using an external Web Server over the WAN port, and the hotspot’s HTTP pages (login or welcome)
redirect to the access point’s WAN IP address for CGI scripts, the IP address of the external Web
server and the access point’s WAN IP address should be entered in the White List.
7. Refer to the Radius Accounting field to enable Radius accounting and specify the a timeout
and retry value for the Radius server.
Login Page URL Define the complete URL for the location of the Login page. The Login screen will prompt
the hotspot user for a username and password to access the Welcome page.
Welcome Page URL Define the complete URL for the location of the Welcome page. The Welcome page asserts
the hotspot user has logged in successfully and can access the Internet.
Fail Page URL Define the complete URL for the location of the Fail page. The Fail screen asserts the
hotspot authentication attempt failed, you are not allowed to access the Internet and you
need to provide correct login information to access the Internet.
No Service Page URL Define the complete URL for the location of the No Service page. The No Service page
asserts the hotspot user has logged in successfully. This page is displayed when the AP is
disconnected from a critical resource such as its AAA server or the wireless controller to
which it is adopted.
This page is also displayed when the AP un-adopts from a wireless controller due to
networking issues. Local AP WLAN must be enabled on the AP for this feature to work.
Enable Accounting Select the Enable Accounting checkbox to enable a Radius Accounting Server used for
Radius accounting for a target hotspot user.
Server Address Specify an IP address for the external Radius Accounting server used to provide Radius
accounting for the hotspot. If using this option, an internal Radius server cannot be used.
The IP address of the internal Radius server is fixed at 127.0.0.1 and cannot be used for
the external Radius server.
Radius Port Specify the port on which the Radius accounting server is listening.