Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 70)

58 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
3
NOTE
If an access point transitions from a one-wlan-radio configuration to a two-wlan-radio config, the
radio’s previous user set values (like maximum MUs on radio) are not remembered and need to be
defined again.
\
CAUTION
Only a qualified wireless network administrator should set the access point radio configuration.
Refer to Configuring the 802.11a/n or 802.11b/g/n Radio on page 5-167 for an understanding
of additional radio values and their implications.
5. Select the Quick Setup screen’s Network Configuration tab to define a minimum set of WAN or
LAN configuration values. The WAN tab displays by default.
2.4 GHz WLAN &
5.0 GHz WLAN only -
no Sensor Not Available Radio 1 WLAN,
Radio 2 WLAN Radio 1 WLAN,
Radio 2 WLAN,
Radio 3 Disabled
Sensor only Spectrum
Analysis mode
(no WLAN) Radio 1 WIPS Radio 1 WIPS,
Radio 2 WIPS Radio 1 WIPS,
Radio 2 WIPS,
Radio 3 Disabled
2.4 GHz WLAN -
no Sensor Radio 1 WLAN (B/G/N) Radio1 WLAN,
Radio 2 Disabled Radio 1 WLAN,
Radio 2 Disabled,
Radio 3 Disabled
5.0 GHz WLAN -
no Sensor Radio 1 WLAN (A/N) Radio1 Disabled,
Radio 2 WLAN Radio 1 Disabled,
Radio 2 WLAN,
Radio 3 Disabled
Radios Off Radio 1 Disabled Radios 1 and 2 Disabled Radios 1, 2 and 3 Disabled