Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 199)

Brocade Mobility 7131 Access Point Product Reference Guide 187
53-1002517-01
5
Creating a LAN IP Filter Policy
The following example uses the access point CLI:
admin(network.lan.ipfpolicy)>add 1 icmp1 incoming deny
admin(network.lan.ipfpolicy)>show 1
------------------------------------------------------------------
Idx Filter-Name Direction Action
------------------------------------------------------------------
1 icmp1 incoming deny
IP Filter Mode : enable
Default Incoming Action : deny
Default Outgoing Action : deny
admin(network.lan.ipfpolicy)>
NOTE
For information on applying a filter to a WLAN or LAN using the access point GUI applet, see, Applying
a Filter to LAN1, LAN2 or a WLAN (1-16) on page 5-183.
Assessing IP Filter Stats
Detailed IP filter statistics can be displayed as follows from the access point CLI:
admin(stats)>show s-wlan 1
Name : joe
ESSID : joe
Authentication : No Authentication
Encryption : No Encryption
Radio/s : 802.11a, 802.11b/g
Number of Associated Clients : 1
Traffic Information:
Packets per second:
Rx : 0 pps
Tx : 0 pps
Total : 0 pps
Throughput:
Rx : 0.00 Mbps
Tx : 0.00 Mbps
Total : 0.00 Mbps
Average Bit Speed : 0.00 Mbps
%Non-Unicast Packets : 0.00 %
RF Status:
Avg MU Signal : 0.0 dBm
Avg MU Noise : 0.0 dBm
Avg MU Signal-to-Noise : 0.0 dB
Error Information:
Average Number of Retries : 0.00 Retries
Dropped Packets : 0.00 %
%Undecryptable Packets : 0.00 %