Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 393)

Brocade Mobility 7131 Access Point Product Reference Guide 381
53-1002517-01
8
admin(system)>
set name phils
admin(system)>
set loc engineering
admin(system)>
set email [email protected]
admin(system)>
set cc us
admin(system)>
set sslv2 enable
admin(system)>
set weak-ssl-cipher enable
admin(system)>
set sshv1 enable
admin(system)>
set dns-relay-mode enable
NOTE
This name will appear in the WIPS server when one of the radios is configured as a sensor and the
WIPS functionality connects to the WIPS server. The WIPS module only accepts names with up to 20
characters, keep that if intending to use this AP as a sensor.
For information on configuring System Settings using the applet (GUI), see Configuring System
Settings on page 4-67. Refer to Appendix A for information on the two-character country codes.
br7131>admin(system)>lastpw
Description:
Displays last expired debug password.
Example:
admin(system)>
lastpw
AP-713X MAC Address is 00:15:70:02:7A:66
Last debug password was admin123
Current debug password used 0 times, valid 4 more time(s)
admin(system)>
br7131>admin(system)>arp
Description:
Dispalys the access point’s arp table.
Example:
admin(system)>
arp
IP Address HWtype HWaddress Flags Mask Device
cc Sets the Mobility 7131 Access Point country code using two letters .
led Sets the access point’s LED state.
dns-relay-mode Enables/disables DNS relay to prevent access to the port used by DNS.
sslv2 Enables/disables SSLv2 support for encryption and message authentication.
weak-ssl-cipher Enables/disables the AP to support SSL ciphers less than 128 bits in length.
sshv1 Enables/disables SSHv1 support for remote connections.