Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 110)

98 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
4
Configuring SNMP RF Trap Thresholds
Use the SNMP RF Trap Threshold screen as a means to track RF activity and the Mobility 7131
Access Point’s radio and associated MU performance. SNMP RF Traps are sent when RF traffic
exceeds defined limits set in the RF Trap Thresholds field of the SNMP RF Traps screen. Thresholds
are displayed for the Mobility 7131 Access Point, WLAN, selected radio and the associated MU.
To configure specific SNMP RF Traps on the Mobility 7131 Access Point:
1. Select System Configuration - > SNMP Access - > SNMP RF Trap Thresholds from the menu
tree.
2. Configure the RF Trap Thresholds field to define device threshold values for SNMP traps.
NOTE
Average Bit Speed,% of Non-Unicast, Average Signal, Average Retries,% Dropped and %
Undecryptable are not access point statistics.
Pkts/s Enter a maximum threshold for the total throughput in Pps (Packets per second).
Throughput Set a maximum threshold for the total throughput in Mbps (Megabits per second).
Average Bit Speed Enter a minimum threshold for the average bit speed in Mbps (Megabits per second).
Average Signal Enter a minimum threshold for the average signal strength in dBm for each device.
Average Retries Set a maximum threshold for the average number of retries for each device.