Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 109)

Brocade Mobility 7131 Access Point Product Reference Guide 97
53-1002517-01
4
4. Configure the Network Traps field to generate traps when the Mobility 7131 Access Point’s link
status changes or when the AP’s firewall detects a DOS attack.
5. Configure the System Traps field to generate traps when the Mobility 7131 Access Point
re-initializes during transmission, saves its configuration file. When a trap is enabled, a trap is
sent every 5 seconds until the condition no longer exists.
6. Click Apply to save any changes to the SNMP Traps screen. Navigating away from the screen
without clicking the Apply button results in all changes to the screen being lost.
7. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on SNMP Traps screen to the last saved configuration.
8. Click Logout to securely exit the Mobility 7131 Access Point Access Point applet. A prompt
displays confirming the logout before the applet is closed.
Physical port status
change Generates a trap whenever the status changes on the Mobility 7131 Access Point. The
physical port status changes when a link is lost between the Mobility 7131 Access Point
and a connected device.
DynDNS Update Generates a trap whenever domain name information is updated as a result of the IP
address associated with that domain being modified.
Denial of service (DOS)
attempts Generates a trap whenever a Denial of Service (DOS) attack is detected by the Mobility
7131 Access Point firewall. A new trap is sent at the specified interval until the attack has
stopped.
Send trap every Defines the interval in seconds the Mobility 7131 Access Point uses to generate a trap until
the Denial of Service attack is stopped. Default is 10 seconds.
WLAN Kerb Auth Failed Generates a trap when the access point detects a WLAN Kerberos authorization failure.
WWAN Event Generates a trap when the access point detects the presence of a 3G WWAN card, the
access point establishes (or fails to establish) a 3G WWAN connection, or the access point
detects a 3G WWAN card disconnection, removal or resumed connection.
System Cold Start Generates a trap when the Mobility 7131 Access Point re-initializes while transmitting,
possibly altering the SNMP agent's configuration or protocol entity implementation.
Configuration Changes Generates a trap whenever changes to the Mobility 7131 Access Point’s configuration file
are saved.
Rogue AP Detection Generates a trap if a Rogue AP is detected by the Mobility 7131 Access Point.
AP Radar Detection Generates a trap if an AP is detected using a form of radar detection.
WPA Counter Measure Generates a trap if an attack is detected against the WPA Key Exchange Mechanism.
MU Hotspot Status Generates a trap when a change to the status of MU hotspot member is detected.
VLAN Generates a trap when a change to a VLAN state is detected.
LAN Monitor Generates a trap when a change to the LAN monitoring state is detected.
Health Check Trap Generates a trap when access to a configured resource such as a RADIUS server or a web
portal is lost.