beautypg.com

Br7131>admin(system.snmp.traps)>add, Description, Syntax: example – Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) User Manual

Page 413

background image

Brocade Mobility 7131 Access Point Product Reference Guide

401

53-1002517-01

8

For information on configuring SNMP traps using the applet (GUI), see Configuring Specific SNMP
Traps on page 4-95
.

br7131>admin(system.snmp.traps)>add

Description:

Adds SNMP trap entries.

Syntax:

Example:

admin(system.snmp.traps)>

add v1v2 203.223.24.2 333 mycomm v1

admin(system.snmp.traps)>

list v1v2c

----------------------------------------------------------------------

index

dest ip

dest port

community

version

----------------------------------------------------------------------

1

203.223.24.2

333

mycomm

v1

admin(system.snmp.traps)>

add v3 201.232.24.33 555 BigBoss none md5

admin(system.snmp.traps)>

list v3 all

index

: 1

destination ip

: 201.232.24.33

destination port

: 555

min-pkt

Sets the minimum number of packets required for rate traps to
fire (

1

-

65535

).

dyndns-update

enable

/

disab

le

Enables/disables dyndns update trap.

wlan-kerb-auth-fail

enable

/

disab

le

Enables/disables the WLAN Kerberos authentication trap.

wwan-event

enable

/

disab

le

Enables/disables the WWAN event trap.

all

enable

/

disab

le

Enables/disables each trap.

health-check-event

enable

/

disab

le

Enables/disables health check event trap.

add v1v2

Adds an entry to the SNMP v1/v2 access list with the destination IP address set to , the destination UDP port set to
, the community string set to (1 to 31 characters), and the SNMP version set to .

v3

Adds an entry to the SNMP v3 access list with the destination IP address set to , the destination UDP port set to
, the username set to (1 to 31 characters), and the authentication type set to one of

none

,

auth

, or

auth/priv

.

The following parameters must be specified if is not

none

:

Authentication type set to

md5

or

sha1

Authentication password (8 to 31 chars)

The following parameters must be specified if is set to

auth/priv

:

Privacy algorithm set to

des

or

aes

Privacy password (8 to 31 chars)