Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 266)

254 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
7
2. Refer to the Information field to reference the following Mobility 7131 Access Point WAN data:
3. Refer to the Received field to reference data received over the Mobility 7131 Access Point WAN
port.
Status The Status field displays Enabled if the WAN interface is enabled on the WAN screen. If
the WAN interface is disabled on the WAN screen, the WAN Stats screen displays no
connection information and statistics. To enable the WAN connection, see Configuring
WAN Settings on page 5-127
HW Address The Media Access Control (MAC) address of the Mobility 7131 Access Point WAN port. The
WAN port MAC address is hard coded at the factory and cannot be changed. For more
information on how access point MAC addresses are assigned, see MAC Address
Assignment on page 1-29.
IP Addresses The displayed Internet Protocol (IP) addresses for the Mobility 7131 Access Point WAN
port.
Mask The Mask field displays the subnet mask number for the Mobility 7131 Access Point’s
WAN connection. This value is set on the WAN screen. Refer to Configuring WAN Settings
on page 5-127 to change the subnet mask.
Link The Link parameter displays Up if the WAN connection is active between the Mobility
7131 Access Point and network, and Down if the WAN connection is interrupted or lost.
Use this information to assess the current connection status of the WAN port.
Speed The WAN connection speed is displayed in Megabits per second (Mbps), for example,
54Mbps. If the throughput speed is not achieved, examine the number of transmit and
receive errors, or consider increasing the supported data rate. To change the data rate of
the 802.11a/n or 802.11b/g/n radio, see Configuring the 802.11a/n or 802.11b/g/n
Radio on page 5-167.