Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 400)

388 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
8
For information on configuring access point access settings using the applet (GUI), see Configuring
Data Access on page 4-77.
br7131>admin(system.access)>show
Description:
Displays the current Mobility 7131 Access Point access permissions and timeout values.
Syntax:
Example:
admin(system.access)>
show
-------------------------------From LAN1-------From LAN2-------From WAN
applet http access enable enable enable
applet http access enable enable enable
cli telnet access enable enable enable
cli ssh access enable enable enable
snmp access enable enable enable
SSLV2 : enable
http/s timeout : 0
ssh server authetnication timeout : 120
ssh server inactivity timeout : 120
admin authetnication mode : local
Login Message Mode : disable
Login Message :
Related Commands:
auth-timout Disables the radio interface if no data activity is detected after the interval
defined. Default is 120 seconds.
inactive-timeout Inactivity interval resulting in the AP terminating its connection.
Default is 120 minutes.
snmp Sets SNMP access parameters for the AP’s LAN and WAN ports.
admin-auth Designates a Radius server is used in the authentication verification.
server Specifies the IP address the Remote Dial-In User Service (RADIUS) server.
port Specifies the port on which the RADIUS server is listening. Default is 1812.
secret Defines the shared secret password for RADIUS server authentication (up to 31
characters).
mode Enables/disables the access point message mode.
msg Defines the access point login message text (up to 511 characters).
show Shows all of the current system access settings for the Mobility 7131 Access Point..
set Defines the Mobility 7131 Access Point system access capabilities and timeout values.