Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 79)

Brocade Mobility 7131 Access Point Product Reference Guide 67
53-1002517-01
Chapter
4
System Configuration
In this chapter
• Configuring System Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 67
• Configuring Power Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70
• Adaptive AP Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75
• Configuring Data Access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77
• Managing Certificate Authority (CA) Certificates . . . . . . . . . . . . . . . . . . . . . . 81
• Configuring SNMP Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87
• Configuring LLDP Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99
• Configuring Network Time Protocol (NTP) . . . . . . . . . . . . . . . . . . . . . . . . . . 100
• Logging Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103
• Importing/Exporting Configurations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104
• Updating Device Firmware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 109
The access point contains a built-in browser interface for system configuration and remote
management using a standard Web browser such as Microsoft Internet Explorer, Netscape
Navigator or Mozilla Firefox (version 0.8 or higher is recommended). The browser interface also
allows for system monitoring of the access point.
Web management of the Mobility 7131 Access Point requires either Microsoft Internet Explorer 5.0
or later or Netscape Navigator 6.0 or later.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available from Sun’s Web site),
and be sure to disable Microsoft’s Java Virtual Machine if installed.
To connect to the access point, an IP address is required. If connected to the access point using the
WAN port, the default static IP address is 10.1.1.1. The default password is “admin123.” If
connected to the access point using the LAN port, the default setting is DHCP client. The user is
required to know the IP address to connect to the access point using a Web browser.
Configuring System Settings
Use the System Settings screen to specify the name and location of the Mobility 7131 Access Point,
assign an email address for the network administrator, restore the AP’s default configuration,
restart the AP or disable the access point’s LEDs.
To configure System Settings for the Mobility 7131 Access Point: