Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 232)

220 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
6
8. Select the Auto (IKE) Key Exchange button.
9. Select Auto Key Settings.
10. Select ESP with Authentication and AES 128-bit. Click OK.
11. Select the IKE Settings button.
12. Select Pre Shared Key (PSK).
13. Enter the Passphrase.
Passphrases must match on both VPN devices.
14. Select AES 128-bit.
15. Select Group 2.
16. Click OK.
This will take you back to the main VPN configuration screen.
17. Click Apply to save the updates
18. Select Network Configuration -> WAN -> VPN -> VPN Status from the Mobility 7131 Access
Point menu tree. Check the VPN status on the access point.
Notice the status displays "NOT_ACTIVE". This screen automatically refreshes to get the
current status of the VPN tunnel. Once the tunnel is active, the IKE_STATE changes from
NOT_CONNECTED to SA_MATURE.
19. On AP #2, repeat the same steps as above. However, replace AP #2 information with AP #1
information.
20. Once both tunnels are established, ping each side to ensure connectivity.