Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 451)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 447
Sierra Trainer Generation Language Teledyne LeCroy
Generation Settings
Setting
Default
Value
Description
Global Settings
GenerationMode
>>>>> Generation Mode ‐ must be defined or no generation
will take place. Possible Values:
GEN_MODE_SATA_HOST GEN_MODE_SATA_DEVICE
GEN_MODE_SAS_INITIATOR
GEN_MODE_SAS_TARGET
Default Value: GEN_MODE_ERROR ‐ undefined mode
SSCEnable 0 Spread Spectrum Clocking (SSC)
In SATA software, turns SSC on or off. Can only be set
outside Generation block.
In SAS software, when you turn on SSC, Trainer PHY
can turn on SSC on the PHY. In the SAS protocol,
during speed negotiation, when both sides of a link
agree to turn on their SSC, SSC will turn on, with the
SSC Type and SSC Amplitude parameters.
SSCType Specifies SSC type as midspread.
SSCAmplitude Specifies SSC Amplitude. Possible values are:
SSC_AMP_500
SSC_AMP_1000
SSC_AMP_1500
SSC_AMP_2000
SSC_AMP_2500
SSC_AMP_3000
MultiSpeedMode 0 When set, the change of speed within Generation
block is allowed with following syntax: set Speed =
LINK_SPEED_1_5G / LINK_SPEED_3G /
LINK_SPEED_6G
Output Disable 0 This very poorly named register bit forces the Trainer
to output data. It is a little like the output_on script
command except that its effect cannot be undone for
the duration of the script. If this is turned on, none of
the out‐of‐band commands will work, as the output
enable is forced on.
SupportSNW1 1 When set, in “Connect command” SNW1 will be tried
in Speed Negotiation phase 
Can only be set outside Generation block.
SupportSNW2 1 When set, in “Connect command” SNW2 will be tried
in Speed Negotiation phase.
Can only be set outside Generation block.