Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 208)

Teledyne LeCroy Target and Device Emulation
206 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
2.6.14 Device Emulator Settings (SATA only)
Click the Settings tab to display the Device Emulator Settings dialog.
The Settings tab opens with a default set of values, which you can modify. To return to
these values, click the Default Settings button.
Figure 2.199: SATA: Device Emulator Settings
PHY/Link layer settings
Enter values for Align Transmission Period, Primitive Response Timeout, and Standby
Timeout, Device send Align Time and Delay between getting HOLD to Sending HOLDA
and specify a delay. Check CONT usage.
Delay Between Getting HOLD to Sending HOLDA
To enable the Delay between getting HOLD to Sending HOLDA feature perform the
following steps:
1. Enter the value in the Delay between getting HOLD to Sending HOLDA field in the
Settings tab as shown in the figure above.
2. Select the Error Injection tab (see Figure 2.200 on page 205 .)