Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 214)

Teledyne LeCroy Target and Device Emulation
212 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
NCQ Command Settings Tab
The following screen capture shows the NCQ Command Settings tab in the Advanced
Target Settings dialog.
Figure 2.206: NCQ Commands
To enable NCQ commands, perform the following steps:
1. Check Support NCQ and specify Queue depth.
2. Optionally check Allow multiple command completion and enter values for Max
time before sending SDP and Max number of command completions reported by
one SDB.