Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 219)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 215
Trace Properties Teledyne LeCroy
3.1.2 Using the Viewer Display
To configure the data viewer display, use the toolbars. You can display the same data in:
 Packet view
 Spreadsheet view
 Column view, with transactions grouped for each active port
 Text view, with transactions grouped for each active port
 Waveform view
 Frame Inspector view
 Histogram view
 Bus Utilization view
 Data Report
 Statistical Report view
 Power Tracker View (SATA)
To change the view type when opening a trace, change the default workspace or save
options in the Preferences dialog in the Trace Viewer tab.
To toggle among open windows, use CTRL ‐ TAB. 
To reverse toggle order, use CTRL ‐ SHIFT ‐ TAB.
To make a frame a trigger pattern, in Packet View, right‐click any frame, select
Add to Trigger, and add the pattern to DataPatternCapture.
Viewer Display enables you to also perform the following:
 Decode Assignments (Refer to “Decoding Assignments” on page 217 for more
details.)
 Compare Two Data Payloads (Refer to “Compare Two Data Payloads” on
page 253 for more details.)
 Run Verification Scripts (Refer to “Running Verification Script Engine (VSE)” on
page 259 for more details.)
3.2 Trace Properties
You can view the Trace Properties from the File menu. Click File > Trace Properties, the
Trace Properties dialog displays with the following information (see
Figure 3.3 on
page 216 ):
 Software version
 Sample file version
 Grouping Type
 Hardware bin file version
 Analyzer armed at
 Analyzer triggered at
 Sample saved at
 Original Capture Project: Open displays the project settings used to capture the
sample.
 Licensing Information
 Simpass Information