Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 159)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 157
Emulation Teledyne LeCroy
Choose Initiator Emulator Port
For each port, select a speed, then click the Speed Negotiation Setting button.
Figure 2.146: SAS: PHY Setting Dialog
Select the port speed settings (see “PHY Setting Dialog” on page 133 ).
After you click OK, you can Enable Muxing On.
Pattern Generator
You can select a Pattern Generation file.
Initiator Emulator
You can run an Initiator Emulator while setting:
 Auto stop Exerciser when Analyzer stopped
 Auto stop Analyzer when Exerciser stopped
 Auto update “Sector Count/Transfer Len” before running
 SAS Address
 Data Frame Payload Size
 Frame Receive Timeout
 Logical Block Size
 ATA Command Execution Timeout
 Send NOTIFY ENABLE SPINUP primitive
Check Autostop Exerciser when Analyzer Stopped to halt the Initiator Emulator when the
Analyzer stops. If unchecked, the Exerciser continues to run even after the Analyzer stops.
Check Autostop Analyzer when Exerciser Stopped to halt the Initiator Emulator when the
Exerciser stops. If unchecked, the Exerciser continues to run even after the Exerciser
stops.