Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 202)

Teledyne LeCroy Target and Device Emulation
200 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
2.6.10 User-Defined Commands Tab
To create command(s) specifically for your application, click the User Defined Commands
tab to display the command definition dialog.
Figure 2.193: SAS: Command Definition Dialog
To define a command:
1. Enter an Operation Code and a Name in the corresponding text boxes.
2. Click the down arrow on the Type combo box and choose a command type.
3. For command types requiring configuration data, click the down arrow on the
enabled Config data: combo box and choose appropriate configuration data.
4. Enter the CDB length: 6, 10, 12, or 16.
5. When done, click the New button.
6. The defined command appears in the command name window.
7. To make changes to a previously defined command, highlight the command, make
the changes, and click Apply.
Note:
After creation, the User‐Defined commands appear in the Event Selection dialog.
2.6.11 Target Emulator Settings (SAS)
Click the Settings tab to display the Target Emulator Settings dialog (see Figure 2.194 on
page 199 ).