Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 136)

Teledyne LeCroy Emulation
134 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
Figure 2.104: SAS/SATA: Power Sources Dialog
2.4.3 PHY Setting Dialog
Sierra M6‐4 and Sierra M6‐2 only: The PHY Setting & Change Speed command supports
1.5, 3, and 6 Gbps speed changing. You can run commands for different speeds, which is
especially useful for device checking. The Analyzer should support the Auto‐Speed mode.
Click the ... button to display the PHY Setting dialog.
Figure 2.105: SAS: PHY Setting Dialog
Select Speed Negotiation Window 1 (1.5 Gbps) or 2 (3 Gbps).
For SNW‐3 PHY Capabilities, you can select Calculate PARITY bit or not.
For Line 0, enter Start, TX SSC Type, and/or Requested Logical Link Rate.
For Line 1, enter G1 without SSC, G1 with SSC, G2 without SSC, G2 with SSC, G3 without
SSC, and G3 with SSC.
2.4.4 Inserting Instructions
Instructions are logical program elements that allow the definition of how the
Initiator Emulator program executes. Using instructions, you can define program loops,
make conditional jumps, and insert delays and stops.