Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 277)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 273
Navigation + View Toolbar Teledyne LeCroy
 SMP Commands
 Task Management Functions
 ATA Commands
 SCSI Command Status (see “Filter Check Condition” on page 273 )
 Source SAS Address
 Destination SAS Address
 Pair SAS Address
 Protocol Error
 STP Port
 Tag (see “Filter by Tag Number” on page 275 )
 ATAPI SCSI Command
 Device Sleep
 Miscellaneous (see “Filter Miscellaneous” on page 276 )
 Training Sequence
Command Data Pattern
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Command Data Patterns in the Sample Viewer.
Bus Condition
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Bus Conditions in the Sample Viewer.
Incomplete Frames
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
Incomplete Frames in the Sample Viewer.
ATA Command
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured ATA commands in the Sample Viewer.
Protocol Error
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured packets with the specified Protocol Errors in the Sample Viewer.
ATAPI SCSI Command
When selected, depending on the Filter Type, the Show/Hide selection shows or hides
ATAPI SCSI commands.
Filter Check Condition
Checking the SCSI Command Status check box enables Check Condition for filtering (see
Figure 3.91 on page 274 ).