Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 207)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 205
Target and Device Emulation Teledyne LeCroy
Power Management Setting
Use the Power Management Setting tab to manage power settings . Enter the relevant
information in the Host Initiated Power Management and Device Initiated Power Management
panes.
Figure 2.198: Power Management Tab
2.6.12 Notes Tab
Click the Notes tab and enter a Project Name and a brief description of the
Target Emulation project (see
“Add a Project Note” on page 115 ).
2.6.13 Run Target Emulation
Click the Start Target Emulator button or select Session > Start Target Emulator
to start emulation.
Note: You can run the analyzer while device emulation is active to monitor bus traffic.