Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 407)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 403
Setting Up for Generating Initiator Traffic Teledyne LeCroy
5.3 Setting Up for Generating Initiator Traffic
Connect the SAS cable from the Target port of the Sierra Analyzer to the Target port on
the unit under test. This transmits the Traffic Generator stream from the Target port to
the target‐side port on the unit under test.
5.4 Setting Up for Generating Target Traffic
Connect the SAS cable from the Initiator port of the Sierra Analyzer to the 
Initiator‐side port on the unit under test. This transmits the Traffic Generator stream from
the Initiator port to the initiator‐side port on the unit under test.
Zoom In. Zoom Out.
Wrap. Find.
Find Next. Start All Generation.
Stop All Generation. Resume All Generation.
Connect All Link. Disconnect All Link.
Setup Generation Options.
Opens the Generation Options
window. Launch Jammer (Infusion).
Launch Analyzer. Start Recording.
Stop Recording. Abort Recording.
Show Port Configuration Dialog.
(See
“Ports Configuration” on
page 109 .)
Show Script Assignment
Dialog.
(See section below.)
Tile Windows
Assign Active Script/
Remove Assigned
Script for 
Link 1, 2, 3, or 4
See
“Multi‐Port Trainer Script
Assignments to Links” on page
416
.