Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 438)

Teledyne LeCroy Sierra Trainer Generation Language
434 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
SPEED_NEG_ALIGN1 Generator will go through SPEED_NEG_ALIGN1
stage of SAS SpeedNeg process using current
SPEED_NEG_ALIGN1 settings.
Set Speed = LINK_SPEED_1_5G Generator will change speed to 1.5G (if
MultiSpeed is enabled)
. 
This settings is not applied when
Advanced Connect is set.
Set Speed = LINK_SPEED_3G Generator will change speed to 3G (if
MultiSpeed is enabled).
This settings is not applied when
Advanced Connect is set.
Set Speed = LINK_SPEED_6G Generator will change speed to 6G (if
MultiSpeed is enabled).
This settings is not applied when
Advanced Connect is set.
DevSlp Makes the device sleep signal high. Trainer
doesn’t go to Electric idle mode automatically
after Devslp command. We can force trainer to
go to DC Idle mode using the “disconnect “
command after Devslp command. This
command works when Generation mode is
GEN_MODE_SAS_INITIATOR or
GEN_MODE_SATA_HOST
Exit_DevSlp Makes Device sleep signal low (comes out of
device sleep mode). This command works when
Generation mode is GEN_MODE_SAS_INITIATOR
or GEN_MODE_SATA_HOST
Send_Phy_Capability Generator will send PHY Capability Bits.
(this command is used in SNW3).
Send_Train_TrainDone Generator will send Train/Train Done Patterns.
(This Command is used in Train Windows).
Delay (#) Generator will wait until # ns before executing
next command.
Power_Expansion_On
Power_Expansion_Off Switch on power expansion card.
Switch off power expansion card
Exit (ExitCode) Call this command in any branch of the Trainer
program to stop execution. After exit, the
Port Status dialog displays the exit code.
Note: The Trainer GUI has LED
indicators:
Green is for pass.
Red is for fail.
No color is for unknown or for
user to review.