Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 213)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 211
Target and Device Emulation Teledyne LeCroy
Figure 2.205: Power Management
1. In the Host Initialized Power Management area, choose whether to support the
report in the Identify page.
2. Specify the response type for PMREQ_P and PMREQ_S, the delay, and Minimum
Number of Response Primitives.
3. In the Device Initiated Power Management area choose whether to support the
report in the Identify page.
4. Define start event by choosing Standby timer expires, STANDBY command
executes, or Link layer remains in IDLE state more than [XXX] ms.
5. Specify time for Abandon request and Wake up after and enter the Standby timer
interval.